![]() I will give examples of both below: :~$ ip routeġ0.0.0.0/24 dev eth0 proto kernel scope link src 10.0.0.100ġ92.168.122.0/24 dev virbr0 proto kernel scope link src 192.168.122.1 linkdownĭestination Gateway Genmask Flags MSS Window irtt Ifaceĭefault DD-WRT.local 0.0.0.0 UG 0 0 0 eth0ġ92.168.122.0 * 255.255.255.0 U 0 0 0 virbr0įor this command to access your router, we are going to use the ip command from a command line in terminal. ip route will show the routes for all network as well as netstat -r. ![]() The ip command, or the older command of netstat can both show you the route that your network follows. ![]() Unless the router you are using needs to be fully reset or your system is not running DHCP to receive IP addresses, the following commands could help you in getting to your router.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |